Skip to main content

What a 5D bend means, and why the D-ratio matters so much

Bend radius in this industry is almost never quoted in millimetres. It is quoted as a multiple of the pipe’s outside diameter, written as a number followed by D.

The definition

A 5D bend has a centreline radius five times the pipe’s outside diameter. On a 273 mm outside diameter pipe, a 5D bend has a centreline radius of 1,365 mm.

The lower the number, the tighter the bend. A 3D bend is tighter than a 5D bend, which is tighter than a 10D bend. A 20D bend is a long, gentle sweep.

Why the number matters so much

When you bend a pipe, the outside of the curve, the extrados, has further to travel than the inside. It stretches, and stretching makes it thinner. The inside, the intrados, compresses and thickens.

How much the extrados thins depends primarily on the D-ratio. Tighter bends stretch the outside further, so they thin more. This is why a tight-radius bend may require you to order heavier-wall pipe than the straight run needs: you are budgeting wall thickness to be consumed by the forming process.

It also determines which process you can use at all. Cold bending typically works at 10D and above. Below that you are into induction bending.

The ambiguity to watch for

“3D” gets used to mean two different things, and we have seen that cause confusion on real jobs.

  • A 3D bend radius means a centreline radius three times the outside diameter.
  • Three-dimensional bending means the bends sit in more than one plane, so the pipe turns and also rises or falls.

We do both. When you send an enquiry, say which one you mean, and we will confirm it back to you in the quote so there is no doubt.

What to specify

Give us the outside diameter, the wall thickness, and either the D-ratio or the centreline radius in millimetres. If you have a minimum remaining wall thickness after forming, say so up front. That tells us what starting wall you need to order, and it is much cheaper to know before the material is bought.

If you are not sure what ratio your geometry is asking for, send us the diameter and the centreline radius and we will confirm the D-ratio back to you.

Induction bending · Send us your geometry

Ready when you are

Send us something to bend.

Diameter, wall thickness, radius, angle, tangent length, material, specification, end prep and coating, and target date. We will respond within one business day.

Benpro Technologies Corporation
4707 Glenmore Trail SE
Calgary, Alberta T2C 2R9
Established 1986