Skip to main content
In-House Coating

Bent, blasted and coated without leaving the facility.

Liquid epoxy applied in our own temperature-controlled booth, to CSA Z245.30, so a coated bend is one purchase order instead of three.

Applying liquid epoxy coating to a pipe bend in Benpro's temperature-controlled coating booth

Benpro applies liquid epoxy coatings in a custom-built, temperature-controlled coating booth at our Calgary facility, in compliance with CSA Z245.30. Systems include Denso Protal 7200 and SP-2888. Because blasting and coating happen in the same building, a finished bend can be surface-prepared to a near-white finish and coated without being exposed to the elements in between.

The argument

One facility, and one party accountable for the result.

The usual arrangement is that a bender bends, then trucks the steel to a coating shop, which schedules it, coats it, and trucks it on. Two schedules, two yards, two sets of handling damage, and nobody who owns the whole outcome.

Ours goes from the bending deck to the blast machine to the coating booth without a trailer in between. If a coating inspection finds something, the bend is fifty metres from the machine that made it.

Coating type

Liquid epoxy

Systems

Denso Protal 7200, SP-2888

Facility

Custom-built temperature-controlled booth, 16.5 m long × 5.5 m wide × 3.7 m high

Standard

CSA Z245.30 · AMPP

Surface preparation

Steel grit blasting to SSPC SP6 and SP10, in-house

Inspection

AMPP Level 2 inspector; coating inspection reports supplied with the job

Standalone

Available

Coating FAQ

Common questions.

What coatings do you apply?

Liquid epoxy (Denso Protal 7200 and SP-2888) applied in a temperature-controlled booth to CSA Z245.30.

Do you coat water-main bends?

Yes. Coated steel water-main bends are regular municipal work for us, with AMPP Level 2 inspection on water-main projects specifically.

Can you bend pipe that is already coated instead?

Yes, that is what our cold decks are for. YJ, YJ2K, UBRA and FBE coated pipe can be cold bent with the coating intact, so you avoid a strip-and-recoat cycle.

Will you coat parts you did not bend?

Yes, we can. Send us the details and we will tell you whether we are the right shop for it.

What surface preparation do you use before coating?

Steel grit blasting to an SSPC SP10 near-white finish, using our own machines with closed-loop grit recycling.

In-house coating

Ship it coated.

One purchase order for the bend, the blast and the coating. We will respond within one business day.

Liquid epoxy
Denso Protal 7200 · SP-2888
CSA Z245.30
Temperature-controlled booth
Blasting at the same facility