Skip to main content

How to specify a bend package so you get an accurate quote first time

We will respond within one business day. Whether that quote is firm or hedged depends mostly on what arrives with the enquiry.

The eight things we need

  1. Outside diameter. In millimetres or inches, either is fine.
  2. Wall thickness. And if there is a minimum remaining wall after forming, tell us that too.
  3. Radius or D-ratio. Centreline radius in millimetres, or the multiple of diameter.
  4. Bend angle. And whether it is a single bend, an S-bend, a compound bend or multi-plane geometry.
  5. Material grade. The full designation: API 5L X65, ASTM A106-B, A333 Grade 6, 316L. If it is sour service, say so and give the category.
  6. Quantity. Including whether the quantity is firm or an estimate.
  7. Governing code. CSA Z245.16, CSA Z245.17, ASME B16.49, ISO 15590, ASME B31.1, plus any client specification layered on top.
  8. Target delivery date and location. The date tells us whether to quote it at all; the location tells us what logistics to build in.

Things that change the quote

Who supplies the pipe. Many customers send their own material. Many ask us to source it. Both are fine, but they produce different quotes and different lead times.

Whether it needs to arrive coated. Coating in our own booth is a different proposition from shipping bare steel, and it is one of the main reasons customers use us.

Whether the ends need machining. If the bend has to tie into a different wall thickness, a machined counterbore transition solves it before the pipe leaves us rather than on your right-of-way.

What documentation the job requires. Bend reports and mill test reports are standard. If your tender or your client specification asks for more, send the requirement rather than assuming.

The easiest option

Send the drawing or the line list. It usually answers all eight questions at once, and it removes the transcription errors that creep in when numbers get retyped into an email.

Our quote form has a field for most of these (put the bend angle under “Anything else we should know”) and takes drawing uploads. If it is urgent, fill the form and then call the shop on 403-255-2944 so it gets flagged.

Ready when you are

Send us something to bend.

Diameter, wall thickness, radius, angle, tangent length, material, specification, end prep and coating, and target date. We will respond within one business day.

Benpro Technologies Corporation
4707 Glenmore Trail SE
Calgary, Alberta T2C 2R9
Established 1986