Skip to main content

What a formed bend gives you that a fitting does not

There is an old line on our original website that deserves reviving, because it is the clearest statement of why this trade exists:

Pipe bending allows you to reduce the number of welds needed in a project, and a formed bend gives you the exact radius and angle you specified rather than the nearest catalogue fitting. The saving shows up in installed cost, in flow, and in what an inspection tool can pass through.

The weld count

A welded elbow needs a circumferential weld at each end. Two welds, per direction change, every time.

A formed bend still needs a weld at each end, exactly like an elbow. What removes welds is a compound bend, where several direction changes are formed on a single length of pipe. On a run with more than one turn, that is where the count comes down.

What each weld costs you

The weld itself is the cheap part. What follows it is not:

  • Non-destructive testing. Every joint gets inspected. Every inspection takes time and produces a record somebody has to review and file.
  • Coating repair. A field weld means a coating holiday at the joint, which means field-applied repair under whatever weather you have that day.
  • Fit-up and pups. Elbows need pup pieces cut, fitted and tracked. Each one is another item on the material list and another opportunity for the wrong thing to arrive.
  • A potential leak path. For the life of the line.

Flow

A long-radius formed bend is a smoother flow path than a welded elbow assembly. Lower pressure drop, less turbulence, and less erosion where the flow turns hardest. On a line that will run for decades, that difference shows up in the operating cost.

The caveats

Bends are not free and they are not always the answer. A bend takes more pipe than an elbow, because you need the tangent lengths and the arc, and on a tight site that length may not exist. Very tight radii can only be achieved by induction bending, which costs more per piece than buying a fitting. And a bend has to be transported as a bend, which is bulkier than a straight length and a box of elbows.

The calculation usually favours bending on anything that will operate at pressure for a long time, and favours fittings on short, low-consequence, space-constrained runs. Send us the geometry and we will tell you which one we would specify.

Induction bending · Compare the methods · Get a number

Ready when you are

Send us something to bend.

Diameter, wall thickness, radius, angle, tangent length, material, specification, end prep and coating, and target date. We will respond within one business day.

Benpro Technologies Corporation
4707 Glenmore Trail SE
Calgary, Alberta T2C 2R9
Established 1986