Most people who call us know the outcome they need and not the process that gets there. That is reasonable. The process is our job. But because the choice changes the price, the schedule and sometimes the material you should order, it is worth understanding the difference before you write the specification.
What induction bending is
An induction coil heats a narrow circumferential band of the pipe to forming temperature. The pipe is pushed forward through that coil while a radial arm holds the centreline, so the bend forms through the hot band. A water quench immediately behind the coil cools the formed section and fixes the geometry.
Only the band being formed is hot. The rest of the pipe stays cool, which is why the process can be controlled precisely and why it can handle material that would crack if you tried to form it cold.
What cold bending is
Cold bending forms the pipe at ambient temperature on a bending deck. No heat is applied at any point. The pipe is clamped, a die of the required radius is engaged, and the bend is made incrementally along the length.
The practical differences
Radius. This is the main one. Induction bending reaches tighter radii. Cold bending typically works at 10D and above, a radius ten times the pipe diameter or more. If your drawing calls for a 3D or 5D bend, that is induction work.
Diameter and wall. Induction handles larger diameters, and a thin wall is often the reason a job goes to induction, because a thin wall ripples in a cold bend. Our induction capacity runs to 36 inches outside diameter; our cold decks go to 20 inches.
Coating. This one runs the other way. If the pipe is already coated (yellow jacket, YJ2K, UBRA or fusion-bonded epoxy), cold bending is almost always the right answer, because the coating never sees heat. An induction bend would destroy the coating in the heat-affected zone and commit you to stripping, re-blasting and re-coating.
Maximum radius. Counter-intuitively, cold bending wins here. Our induction maximum is 10 metres. On a cold bend the maximum radius is limited only by the length of pipe.
A rough decision rule
Tight radius, thin wall or large diameter: induction. Generous radius, smaller diameter, and especially pipe that arrives already coated: cold. If you are between the two, send us the numbers and we will tell you which is cheaper and which is faster, because they are not always the same answer.
The standards changed in 2022
Worth knowing: until August 2022 both processes sat inside CSA Z245.11. They were then split into separate standards: CSA Z245.16 for induction bends and CSA Z245.17 for cold bends. If your specification still references Z245.11 for bends, it is worth updating.
More on induction bending · More on cold pipe bending · Send us the numbers
